Current MeshCom 4.0 MC firmware 4.34e release
2025-01-09 4.34e
- T-LORA nodes improved. That these do not break off the LoRa-RX after some time
- BME/BMP280,... sometimes got stuck in a value loop ... has been eliminated
- ESP32 LoRa chip setting interrupts has been improved/renewed
- ESP32 current RadioLib has been changed to 7.1.1
Here is the link to the WEB-Flasher : https://oe1kfr.com/esptool/
Hello, I have just received the t-deck plus (incl. GPS). Unfortunately the device does not come with a manual, is there a download link?
If I copy the Set.up file incl. FW bin to the SD card, I probably don't need the installer file (this would probably only be required for an installation via PC?) How do I have to start the device with the inserted SD card so that the setup is read? Thanks in advance for your support! 73, Peter OE3PEA
1) T-Deck switched off
2) Hold down the trackball
3) Switch on T-Deck
4) Release the trackball
It is then in flash mode
Start the WEB-Flasher https://oe1kfr.com/esptool/ and
- Category release
- FW version 4.28b
- Board T-Deck
- Connect