MeshCom 4.0 FAQ APP

Questions and answers about the iPhone and Android app

Q: What do I have to do if I use a FW version 4.34n or higher?

A: If a newer FW version is used, the following steps must be followed:

• also select "ERASE" for the 1st FW flash
• Delete the existing old pairing manually on the phone
• Then the APP can be called up the first time you connect, a security message appears
  • BLE connected
    Encrypt connection failed - disconnecting client
    BLE disconnected. Reason: 534
• The APP disconnects automatically
• Connect the APP again and you will receive confirmation
  • BLE Connected with: xx:xx:xx:xx:xx:xx:xx
    BLE connected

• After that everything works

Q: How do BUTTONs react in the APP?

A: When you operate a button, please always remember that when the button is pressed, the command is first sent to the node, where the firmware processes the action and then the setting is sent back to the app.
ONLY THEN does the state of the buttons or settings change. This can take a few seconds, especially if you switch a sensor on/off, for example.